Industrial Hose Products Catalog Goodyear Rubber Products





	Home About Us Location Maps Products Full PDF Catalogs Quote Contact Us

<< Previous Page

Click Here to open this page in a new window.

Next Page >>

Catalog  #07-130
                                                                                                             Supersedes Catalog #03-130
      Air &
  Multipurpose
  General Purpose        APPENDIX-GENERAL  INFORMATION
    Heavy Duty
     Push-on
                                              PALADIN DROP HOSE COUPLING PROCEDURE USING
                                        CAM AND GROOVE FITTINGS WITH GOODYEAR BANDING COIL
    Chemical
     Transfer
                         1.  If hose conductivity is required refer to NAHAD Hose Assembly Guidelines.
    Cleaning             2.  Cut banding coil to appropriate length (approximately 6" to 8" of banding coil per hose
    Equipment                end) to insure complete coverage of the coupling insert inside the hose.
                         3.  Looking down the end of the hose, screw or band, in a counter-clockwise motion, the
      Food
                             banding coil onto the end of the hose; filling the cover depressions between the PVC
     Transfer
                             helix.
    Washdown
                         4.  Install the fitting insert into the end of the hose.
     Marine
                         5.  Making sure the banding coil is tight around the hose, and properly filling the cover
                             depressions, install the first 3/4" metal hose strap (closest to the hose end) so when
Material Handling
                             tension is applied, the 3/4" metal strap will rotate in a counter-clockwise motion
     Abrasives
   Bulk Transfer             causing the banding coil to tighten down further onto the hose.
 Cement & Concrete
                         6.  Install the second metal hose strap (properly spaced) behind the first metal strap using
                             the same procedure as outlined in #5 above.
      Mining
                         TECHNICAL RECOMMENDATIONS:
    Petroleum
  Aircraft Fueling
                         ·   The counter-clockwise motion is required. Application of the 3/4" metal straps in any
    Dispensing
                             other fashion will cause loosening of the banding coil and reduced coupling retention.
       Dock
     Transfer
                         ·   3" I.D. drop hose requires a 2 1/2" banding coil.
      Spray              ·   4" I.D. drop hose require a 3 1/2" banding coil.
                         ·   Ten (10) turns of the banding coil will assure coverage of the coupling insert, regardless
      Steam
                             of the hose I.D.
     Vacuum              ·   Always align the 3/4" metal straps with the coupling insert barbs or nodes. To be sure
                             the metal straps are in the proper position, it is recommended the hose cover be
      Water                  marked where the barbs/nodes are located.
    Discharge
                         ·   The use of two (2) each 3/4" stainless steel, "performed," center punched or rolled
    Suction &
    Discharge                over metal straps is recommended.
    Washdown
                         ·   Tightening the 3/4" metal straps with a hand tool is recommended.
     Welding
    Coupling
    Systems
    Appendix
     Additional
     Products
  Chemical Charts
     General
    Information
   Minimum Run
   Requirements
                                                                                                 © 2007 The Goodyear Tire & Rubber Company.
                                                                                274