Full PDF Catalogs
<< Previous Page
to open this page in a new window.
Next Page >>
D Inverted Inverted Flared Fittings Advantages Order Built to resist mechanical pullout.This economical fitting can be By part number and name. Bodies and nuts are separate items and assembled and disassembled repeatedly. Readily available in a broadindividual part numbers must be indicated when ordered. selection of styles to fill your specific needs. Manufactured from CA 360 or CA 345 brass. Nomenclature Part numbers are constructed from symbols that identify the style and Specifications size of the fitting. The first series of numbers and letters identifies the Listed with Underwriter's Laboratories for flammable liquid and gas .style and type fitting. The second series of numbers describes the size. Meets functional requirements of SAE, J512, ASA and MS (Military Standards). Refer to list of UL listed fittings on page M10 for specificExample: 48 1F 1FHD 4 2 configurations. Half Union Applications Inverted Flared (Light Duty) Use with copper, brass, aluminum and welded steel hydraulic tubing Inverted Flared (Heavy Duty) that can be flared. Manufactured especially for hard-to-hold liquids and 1/4" (4/16) tube O.D. gases. 1/8" (2/16) pipe thread Working Pressure Ranges Sizes Temperature and type of tubing used are important factors. However, Tube sizes are determined by the numbers of sixteenths of an inch in the following table is a good guide for proper selection.Temperature the tube O.D. 73°F with copper tubing: Special Fittings PSI TUBE TUBE Fitting configurations and/or sizes other than those shown in the O.D. (IN.) WALL (IN.) catalog can be furnished. It is suggested that a print or sketch be 2800 1/8 .030 submitted with the inquiry. Special UL stamped fittings are available. 1900 3/16 .030 Please consult price list. 1400 1/4 .030 1200 5/16 .032 1000 3/8 .032 Pricing 750 1/2 .032 Only items priced in current supplementary price list PL3501 are 650 5/8 .035 carried in stock. Price and delivery for non-stock items furnished on 550 3/4 .035 request for specified quantity. Temperature Ranges From -65° to +250°F. Vibration Will withstand minimal vibration movements. Assembly Instructions 1. Cut tubing squarely and clean tube end thoroughly to remove burrs. 2. Place nut onto tube. Place threaded end of nut toward end of tube. 3. On thin wall copper, welded or brazed tubing, use double flare to prevent pinch-off or cracked flares. 4. Clamp tube flare between nut and flare seat of body by screwing nut on finger-tight. Tighten with a wrench an additional 1/4 turn for a metal-to-metal seal. Note: The seat dimensions are predicated on practical threading limitations and use of these fittings with double flared tubing. Parker Hannifin Corporation D14 Parker Brass Products Division Inverted Otsego, Michigan