Parker Hannifin Corporation
Fluid System Connectors
Otsego, Michigan
D14
Catalog 3501E
Metric Prestomatic Air Brake
Push-In Fittings
Applicable Tube
Tube Material:
DIN 73378 virgin nylon,
SAE J844 tubing
Tube O.D. (MM):
6, 8, 10, 12, 16
Patented design of sizes 6mm and above meet DIN 74324 and D.O.T.
FMVSS 571.106 air brake performance specifications. Just bottom the
tubing in the fitting body for a positive seal.
Materials of Construction
Fitting Bodies:
Brass
Collet:
Brass
Tube support:
Stainless Steel
O-ring:
Buna N
Nomenclature
Example: f8upmtb8m22
Attribute:
f
Straight Male
Connector
8
Metric Parallel
u
Universal Stud
pmtb
Air Brake Push-In
Fitting–Brass Body
8
8
mm Tube Size
m22
22
mm Port Thread
Assembly Instructions
1.
Cut tubing squarely–maximum of 15° angle allowable.
•
Use of Parker tube cutter PTC-001 is recommended.
2.
Check that port or mating part is clean and free of debris.
3.
Insert tubing into fitting until it bottoms.
•
Push twice to verify that tubing is inserted past collet and O-Ring.
4.
Pull on tubing to verify it is fully inserted.
5.
To disassemble, simply press release button, hold against body, and pull tubing out of fitting.
Note: in order to pass hot pull requirements of
SAE FMVSS 571.106 and SAE J2494-3 a tube support
must be present in the end of the fitting before final fitting assembly.
Insert tubing until it bottoms
Depress button to remove tubing
PTC-001
Specifications
pRESSURE
RANGE:
Up to 250 PSI
Temperature
Ranges:
-40
° to +200°F