Parker Hannifin Corporation
Fluid System Connectors
Otsego, Michigan
L3
Catalog 3501E
Blow Guns
Controlled Pressure Blow Guns
Parker Controlled Pressure Blow Guns meet OSHA requirements (section 29 CFR 1910.242
paragraph b), and directive #100-1. “Compressed air shall not be used for cleaning purposes
except where reduced to less than 30 psi, and then only with effective chip guarding and
personal protective equipment.”
Parker Controlled Pressure Blow Guns have a black epoxy coated zinc body and vented nozzles
to prevent pressure build-up when dead ending occurs up to 150 psi.
Full Pressure Blow Guns
The following Parker Blow Guns must have a pressure regulator setting below 30 psi to conform
to OSHA safety requirements 29 CFR 1910.242 Paragraph b.
Specifications
Part No.
Maximum
Pressure PSI
Wt. (LB)
P/Piece
410-
S
150
.50
410-
SV
150
.53
415-
S
150
.48
Specifications
Part No.
Maximum
Pressure PSI
Wt. (LB)
P/Piece
410
150
.48
410-
N
150
.51
415-
N
150
.49
410-
S
Parker Controlled Pressure Blow Guns
features thumb lever valve actuator and brass
nozzle. Inlet port is 1/4” NPT.
410
Parker two way thumb lever valve has an zinc
body with 1/4” NPT inlet and 1/8” NPSF outlet.
Note: Standard Gun without nozzle.
410-
SV
Parker Venturi Nozzle Controlled Pressure
Blow Gun with thumb lever valve and large
venturi side ports for high volume flow. Inlet
port is 1/4” NPT.
410-
N
Parker thumb lever style Blow Gun features
a zinc body, brass nozzle, and 1/4” NPT
female inlet.
415-
S
Parker Controlled Pressure Blow Guns
features push button valve actuator and brass
nozzle. Inlet port is 1/4” NPT.
415-
N
Parker Blow Gun features a push button style
actuator, zinc body with a brass nozzle and
1/4”
NPT female inlet.
400-
S-TIP
Blow Gun Replacement Tip