T7
Parker Hannifin Corporation
Tube Fittings Division
Columbus, Ohio
http://www.parker.com/tfd
4300
Catalog
General Technical
In hydraulic systems, pressure drop represents loss
of energy and therefore should be kept to a minimum.
Pressure loss in straight tubing and hose is mainly
caused by the frictional resistance of the walls, while in
fittings it is mainly caused by changes in the magnitude
or direction of the fluid velocity. Mathematical
analysis of pressure drop, even though possible, may not be
exact because of the interrelationship of factors such as
fluid density, velocity, flow area and frictional coefficients.
The following pressure drop charts were derived from actual
test dataandmaybeusedasaguide for determiningpressure
drops at various flow rates through fittings for fluid indicated.
To determine pressure drop for a given flow, trace a vertical
line up from the flow axis to the desired size line then trace
a horizontal line from this intersection over to the pressure
drop axis.
Example:
Asize8CTX, withoil, similar to the test fluid, flowing
throughitat4gallonsperminute,wouldcauseapressuredrop
of approximately 2.3 psi. Conversions will have to be made
for fluids which are not similar to test fluid.
The Tube Fittings part numbers are listed below the Pres-
sure Drop Chart to which they apply.
Tube Fittings Pressure Drop
Fig. T3 — Pressure Drop Chart for 90°Fittings or Branch Path Through a Tee or Cross Fitting (Triple-Lok)
Pressure Drops for Other Fitting:
*
These pressure drop curves were established with Triple-Lok fittings. The pressure drop values can be adjusted
for other fittings of the same size by multiplying the value from the chart by the ratio of Triple-Lok flow diameter
to that of the other fitting, raised to the 4th power.
Example:
Find pressure drop for 6 C5L at 5 gallons per minute flow rate:
From the chart, the pressure drop for 6 C5X is 10 psi.
Also, the ratio of 6 C5X to 6 C5L flow diameters is 0.297/0.264, or 1.125.
Therefore, the pressure drop for Seal-Lok = 10 x (1.125)4 = 16 psi.
Pressure Drops for Other Fluids:
Pressure drop through a fitting is mainly caused by change in direction and velocity of the fluid. Therefore, it is directly
proportional to the specific gravity of the fluid. The drop due to friction, which is dependent on the viscosity of the fluid,
is so small in this case that it can be ignored. Thus, the pressure drop with a different fluid can be calculated by multiplying
the value from the graph above by the ratio of specific gravity of the two fluids, or:
New Drop = Value from the graph x Specific Gravity of New Fluid
Specific Gravity of Test Fluid (0.873)
S
Dimensions and pressures for reference only, subject to change.
link