Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
Catalog 4400 US 22 Series Fittings Use with 201, 206, 221FR, 225, 22 Series Assembly Instructions 266, SS25UL hoses. 22 Series (Mandrel Style) Hose Assembly Instructions 1. Identify over all length (OAL) of hose assembly and the cut off A allowance (COA) length of fitting(s) on hose ends by use of A the fitting data table. Properly measure, mark and cut hose to desired length using fine tooth hacksaw or a cutoff ma- chine. Care should be taken to ensure a square, clean cut is obtained. Air or solvent flush cut end of hose as necessary to produce a clean hose ID prior to assembly. Place socket in 1 vice and screw in hose counter clockwise until hose bottoms. Back hose out � turn. 2. When assembling male pipe ends, slide nipple onto mandrel. 3. When assembling swivel ends, slide swivel nut over nipple. B Slide nut and nipple onto mandrel. Screw mandrel threads into nipple and wrench tighten. 4. Oil inside of hose and nipple threads liberally with Hoze-Oil. 2 (See Section C). Do not oil hose cover. 5. Push nipple into socket. � Male ends: Thread nipple in until it bottoms against socket. � Swivel ends: Thread nipple into socket using hex on as- sembly mandrel. Leave clearance of approximately 1/32" (.784mm) between nut and socket to allow nut to swivel. C Remove mandrel. Note: Disassemble in reverse order. 3 Caution: Do Not Attempt to Assemble These Fittings to the Hose Without Using a Mandrel. Inspection. Examine hose assembly internally for cut or bulged tube, obstructions and cleanliness. Clean ID of hose as neces- sary. Swivel nuts should turn freely. Check the layline of the hose to be sure the assembly is not twisted. Cap the ends of the assembly to keep clean. D Special Instructions for Refrigerant Hose. Oil inside of hose 4 and nipple threads liberally with the same oil used in refrigeration Fittings Hydraulic system. Do not oil hose cover. Do not allow hose to contact TechnicalAccessoriesEquipmentHoseSeries22 Hose any petroleum base fluids. E 5 B-145 Hose Products Division Parker Hannifin Corporation Wickliffe, Ohio
Goodyear Rubber Products
