Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
Hydraulic&AlphanumericThermoplasticPTFE&TechnicalTooling&HoseCoiledAirHose,(Fleet)TruckApprovals& PneumaticIndexTubing&HoseDesignEquipmentAccessoriesFittingsProductsGuidesFit. Hose Assembly & Fittings Nomenclature &HoseFittingsInformation&Accessories Hose Assembly Nomenclature F 540N 06 39 08 08 08 C 30 N/A Fitting 1st Fitting 2nd Size End Con- End Con- Size 1st 2nd Hose End Fitting Displacement Prefix Hose Type figuration figuration End End Dash Size Matl Length Angle F= Crimp Blank= Overall Specified only if two Steel Length elbow fittings are used. R= Field always Starting with either end Attachable C= Stain- expressed as the far end, measure Ftng less in inches the angle clockwise to A= 54 B= Brass describe the displace- If elbow Series ment of the near end. fittings are Factory used, overall NEAR END length is measured from the centerline 270� or the seat FAR END This assembly example reflects a 1/2" ID 540N hose The first fitting configuration callout is 10655-8-8 with an SAE 1/2" female JIC 37� straight fitting on The second fitting configuration callout is 13955-8-8 the first end and an SAE 1/2" 90� female JIC 37� elbow fitting on the other. The fittings are crimped Special Notes (permanently attached) and stainless steel. The overall length is 30". TM Seal-Lok fittings are always measured to the sealing surface The callout for this completed hose assembly would be: F540N0639080808C-30" Hose Fittings Nomenclature 1 03 55 8 6 N/A End Configuration Type Code Series of Fitting End Size Hose Size Material 1=Crimp Blank=Steel 2=Field Attachable B=All Brass C=Stainless Steel S= All Carbon Steel-Used only with PTFE fittings This example describes a permanent crimp 1/2" Male SAE JIC 37� hose end with a 3/8" hose end-this com- monly referred to as a "jump size". This fitting is constructed from carbon steel since the designated material is blank. The callout is: 10355-8-6 Other end configuration codes found on page 37. 8 Parker Hannifin Corporation Parflex Division Ravenna, Ohio
Goodyear Rubber Products
