Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
(Fleet)TruckPTFE Technical&Hydraulic&ThermoplasticAlphanumericTooling&CoiledHose,HoseAirApprovals& ProductsHose& PneumaticDesignTubingIndexAccessoriesEquipmentFittingsGuides PTFE Hose Assembly & Fittings Nomenclature FittingsHose&Fit.Information&Accessories Hose Assembly Nomenclature P 919 06 39 08 08 08 C 30 N/A Size Size Hose Fitting 1st End Fitting 2nd End 1st 2nd Hose End Fitting Displacement Prefix Type Configuration Configuration End End Dash Size Material Length Angle R= Field Attachable Blank= Steel Overall Specified only if two Fitting Length elbow fittings are used. C= Stainless always Starting with either end P= Permanent B= Brass expressed as the far end, Crimp 91N & 93N in inches measure the angle Series clockwise to describe If elbow F= 91 Series Crimp the displacement of the fittings are near end. used NEAR overall END length is measured from the centerline 270� or the seat FAR END This assembly example reflects a 1/2" ID 919 hose Special Notes with an SAE 1/2" female JIC 37� straight fitting on Assemblies are to be measured extreme end to end. the first end and an SAE 1/2" 90� female JIC 37� Exceptions: elbow fitting on the other. The fittings are crimped 1. Face seal type fittings shall be measured from (permanently attached) and stainless steel. The sealing face. overall length is 30". 2. Where elbow fittings are used, measurement The first fitting part number is 10691N-8-8 shall be to the centerline of the sealing surface of The second fitting part number is 13991N-8-8 the elbow end. 3. "A-LOK" and "CPI" fittings are measured from the tube stops. Hose Fittings Nomenclature 1 03 91N 8 End Configuration Type Code Series of Fitting End Size Hose Size Material 1=Crimp Blank=Steel or Brass/ 2=Field Attachable Steel B=All Brass C=Stainless Steel S= All Carbon Steel This example describes a permanent crimp 1/2" Male SAE JIC 37� hose end with a 3/8" hose end-this com- monly referred to as a "jump size". This fitting is constructed from carbon steel since the designated material is blank. The callout is: 10391N-8-6 Other end configuration codes found on page 36. 132 Parker Hannifin Corporation Parflex Division Ravenna, Ohio
Goodyear Rubber Products
