Page 242 - Catalog4400.pdf

B-150

Hose Products Division

Parker Hannifn Corporation

Wickliffe, Ohio

www.parkerhose.com

20 Series Fittings

Catalog 4400 US

Use with

201,

206,

266,

221FR,

and

SS25UL h

oses.

A

B

C

D

E

Assembly Instructions

20 Series Hose Assembly Instructions

1. Identify over all length (OAL) of hose assembly and the cut

off allowance (COA) length of ftting(s) on hose ends by use

of the ftting data table. Properly measure, mark and cut hose

to desired length using fne tooth hacksaw or cutoff machine.

Care should be taken to ensure a square, clean cut is

obtained.

2. Air or solvent fush cut end of hose as necessary to produce

a clean hose ID prior to assembly. Place socket in vice and

screw in hose counter clockwise until hose bottoms. Back

hose out ½ turn.

3. Oil inside of hose and nipple threads liberally with Hoze-Oil.

(See Section C)

. Do not oil hose cover.

4. Screw nipple assembly into socket using a wrench on the

nipple hex until the nipple hex shoulders against the socket.

A 1/32” to 1/16” gap between the nipple hex and socket is

allowed for displacement angle adjustment when two elbow

fttings are used.

Inspection.

Examine hose assembly internally for cut or bulged

tube, obstructions and cleanliness. Clean ID of hose as neces-

sary. Swivel nuts should turn freely. Check the layline of the hose

to be sure the assembly is not twisted. Cap the ends of the

assembly to keep clean.

Special Instructions for stainless steel fttings.

When

assembling fttings made with 316 stainless steel, lubricate the

threads of both the socket and nipple with Accrolube High

Effciency Lubricant

(see Section C)

or equivalent metal

assembly lubricant.

Note: DISASSEMBLE IN REVERSE ORDER

IF YOU HAVE QUESTIONS CONCERNING THE PRODUCTS

OR APPLICATION OF THE PRODUCTS CONTAINED IN THIS

CATALOG, PLEASE CALL: PARKER HOSE PRODUCTS

DIVISION - TECHNICAL SERVICES DEPARTMENT

PHONE: 440/943-5700

FAX: 440/943-3129

http://www.parkerhose.com

1

2

3

4