Goodyear Rubber Products





	Home About Us Location Maps Products Full PDF Catalogs Quote Contact Us

<< Previous Page

Click Here to open this page in a new window.

Next Page >>

STRENGTHEN  KEYED ASSEMBLIES                                                                                    SHAFT MOUNTED ASSEMBLIES
   REPAIRING BADLY WALLOWED KEYWAY                                                                                                        REPAIRING BADLY WORN SHAFT
     660TM Quick Metal® Coated Keyway
                                                                                                                                                             Bearing
                                                                                                                                                               660TM Quick Metal®
                                                                                                                                                               Sleeve
                                                                                                                                                              680TM or
                                                                                                                                                              660TM Quick Metal®
                                                                                                                                                  Shaft
  1.   Clean all parts with Loctite® ODC-Free Cleaner & Degreaser.
                                                                                                          1.   Determine a minimum radial gap.
  2.   If necessary, spray all parts with Loctite® 7649TM Primer NTM. Allow to dry.
                                                                                                          2.   Select and trim appropriate sleeve to allow component slip fit.
  3.   Apply a Loctite® 660TM Quick Metal® Retaining Compound coating
                                                                                                          3.   Roughen sleeve O.D. with emery cloth.
       into keyway.
                                                                                                          4.   Clean all parts with Loctite® ODC-Free Cleaner & Degreaser.
  4.   Assemble as required using Loctite® 660TM Quick Metal® Retaining
                                                                                                          5.   Apply a Loctite® 680TM or Loctite® 660TM Quick Metal® Retaining
       Compound.
                                                                                                               Compound coating around the shaft.
  5.   Allow 30-60 minute cure time.
                                                                                                          6.   Install sleeve.
                                                                                                          7.   Apply a coating of Loctite® 660TM Quick Metal® Retaining Compound to
       Note:  · Loctite® 660TM Quick Metal® Retaining Compound is NOT
                                                                                                               sleeve O.D.
                recommended for lateral gaps exceeding .010".
                                                                                                          8.   Install component as required onto sleeved shaft.
              · Higher strengths are obtained by NOT using Loctite® 7649TM
                                                                                                          9.   Allow 30-60 minute cure.
                Primer NTM with small (.002"-.004") gap, and allowing longer
                cure (4-24 hours).
                                                                                                               Note:  · Loctite® 660TM Quick Metal® Retaining Compound is NOT
                                                                                                                        recommended for radial gaps exceeding .010".
                                                                                                                      · Higher strengths are obtained by NOT using Loctite® 7649TM
                                                                                                                        Primer NTM with small (.002"-.004") gap, and allowing longer
                                                                                                                        cure (4-24 hours).
18                                                                                                                                                                                         19